SLC Smart One S24019 Quick Start Guide
1. Wiring diagram
2. Connect the SmartOne dimmer to a Zigbee Smart Hub
3. TouchLink to a Zigbee remote
4. Set minimum brightness setting
5. Set startup brightness
6. Factory reset
Wiring diagram
Note: An authorized electrician must install this device. Remember to switch off the power before installing.
Connect the SmartOne dimmer to a Zigbee Smart Hub
1. Choose to add a new light from your compatible Zigbee Hub Interface
2. Your interface is now searching for new Zigbee devices on the network
3. Press the programming button 5 times to set the device in pairing mode for 15 sec.
4. Once your smart hub as successfully paired with the SmartOne dimmer, all connected lights will flash twice (slowly).
Troubleshooting:
1. Try step 1-4 again
2. Reset the SmartOne Dimmer to factory settings, and then try step 1-4 again. Click here>>
TouchLink the SmartOne Dimmer to a remote
1. Press the programming button on the dimmer 4 times to set the device in pairing mode.
2. Bring the remote within 10 cm of the dimmer.
3. Activate TouchLink paring mode on the remote. (SmartOne Remote Quick Guides).
Set minimum brightness
1. Adjust the brightness setting between 1-50% on your Smart Hub interface
2. Press and hold the left button on the SmartOne dimmer for 3 sec.
3. Now the load can not be dimmed below the set level.
Note: To remove this setting simply adust the brightness to 100% and then hold the same button for 3 sec again. Then the minimum brightness setting will be removed.
Set startup brightness
1. Adjust the brightness setting between 1-50% on your Smart Hub interface
2. Double click the left button on the SmartOne dimmer.
3. Now the load will first go to startup brightness when turned on every time, and then adjust to the last brightness setting.
Note: To remove this setting simply adust the brightness to 0% and then double click the same button again. Then the startup brightness setting will be removed.
Factory reset
1. Delete the SmartOne dimmer from your Zigbee Hub Interface
2. Short press the reset button on the SmartOne dimmer 5 times.
3. Connected lights will blink 3 times to indicate a successful reset.