SLC Smart One S24020 Quick Start Guide

1. Connect the SmartOne PSU to a Zigbee Smart Hub
2. TouchLink to a Zigbee Remote
3. Reset to Factory settings
4. Wiring Diagram

Zigbee Network pairing through a Zigbee Gateway/Hub

1. Choose to add a new light from your compatible Zigbee Hub Interface. Your interface is now searching for new Zigbee devices on the network.

2. Press the programming button 5 times on the SmartOne Controller. 

3. The Controller will turn up in your Hub Interface. 

Troubleshooting:

1. Try step 1-3 again

2. Reset the SmartOne Controller to factory settings (Step 2), and then try step 1-3 again.

TouchLink to a Zigbee Lighting Device

1. Press the programming button on the SmartOne Controller 4 times. 

2. Bring the remote close and begin TouchLink pairing. 

The lights will blink to confirm a sucsessful pair. 

Troubleshooting:

1. Factory reset the remote, see user manual. (SmartOne Remotes: Quick Guides).

2. Try step 1-2 again. 

Factory reset the SmartOne Controller

1. Press the programming button on the SmartOne Controller 5 times. 

Note: This will erase all bindigs to the device and start pairing mode. (15 seconds timeout).

Wiring Diagram